Brother Z-8550A 사용자 매뉴얼

 

 

Z-8550A, 8560A 

75 

Adjust the position of the needle so that it is in about the 
center of the slot in the needle hole when the power is 
turned on and the zigzag width and zigzag base line position 
have both been set to 0 mm at the operation panel. 
*  When the straight stitch key on the operation panel is 

pressed, the zigzag width will be set to 0.0 mm. 

 

1.  Turn off the power switch. 
2.  Remove the presser foot, rear cover (1) and window 

plate (2) and also the solenoid for the 8560A). (Keep 
them removed while adjustment is being carried out.) 

3.  Loosen the bolt (4) of the zigzag joint (3) and adjust the 

needle position. In addition, set the motor lever (5) so 
that the longer part is vertical. 

4.  Turn on the power switch. 

*  If “UP” is displayed, turn the machine pulley until the 

display disappears. 

5.  Press the TEST key (6) on the operation panel and 

check that the TEST icon (7) illuminates.   
(For safety purposes, be sure to carry out this step. It 
prevents the motor from operating even if the treadle is 
depressed.) 

6.  Press the straight stitch key (8) on the operation panel. 
7.  Adjust the position of the needle so that it is at the center 

of the needle hole (slot). 

8.  Securely tighten the bolt (4). 

*  When tightening the bolt (4), be careful not to apply to 

much pressure to it or to twist the zigzag joint (3). 

9.  Press the TEST key (6) on the operation panel (the 

TEST icon (7) will switch off) to return the sewing 
machine to normal sewing mode. 

10.  Turn off the power switch. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

0218B

0151B

0150B

0149B