Bracketron Multi Vehicle Mount MVM-15-05 사용자 설명서

To modify the MVM, start by fl attening the existing bends shown in 

picture 1 on the left. Place the MVM on the fl at spot of the bench vise and 

pound out the bends until the MVM is fl at and looks like picture 2 on the 

left.

Use the tin snips to cut away the parts of the mount that are not needed 

as shown in Picture 3 on the left. Once the MVM is cut, bend the remain-

ing tab into a 90 degree angle. The bend does not need to be a sharpe 

90 degree bend, it just has to bend enough to allow you to mount it using 

the exsiting screw hole as shown on page 1.

Return to step 3 on page 1.

MVM Instructions | 

The Bracketron MVM-15-05 mount is a modifi able mounting bracket. The illustrations on the left show how this mount should 

look during and after the modifi cation steps in order to fi t the listed vehicles on the front page of this manual. 

Many vehicle 

applications may not require any modifi cations to the mount. If this is the case it will be noted below and there will be no steps 

to follow on this page. 

 

© Bracketron Inc, 2007 All rights reserved.

The information in this document is subject to change without notice. Bracketron Inc. assumes no responsibility for any errors that may appear in this document nor 

do we assume any liability in connection with its use. This supersedes and voids all previous literature. Please contact the sales department for additional information. 

Bracketron Inc will not be responsible or liable for damage to vehicles in the installation and or removal of this Bracketron Inc mount. Bracketron Inc will not be liable 

for personal injuries or damage to property resulting from a motor vehicle accident and or improper installation of this Bracketron Inc mount. 

 Please see page 3 in this manual for PHS-

Bracketron Inc

 5249 West 73rd Street, Suite G, Edina, MN 55439 

tel:

  952-746-7775  

fax:

 1-800-660-1784  

toll free:

 1-866-237-4443

email:  

sales@bracketron.com

 web:

  www.bracketron.com