Bracketron MULTI VEHICLE MOUNT MVM-45-05 사용자 설명서

MVM Instructions | 

IMPORTANT INFORMATION
Please read instructions completely before installing this Bracketron MVM Mount. All instructions are written from the drivers seat van-

tage point looking forward at the vehicles dash. We advise caution whenever you are removing or handling plastic parts of a vehicles 

dash. 

Unnecessary force or pressure can cause pieces to crack or break.

PARTS INCLUDED: MVM-45-05 Mount, 3 - #8x3/4” Self Tapping Screws, 2 - M4x8 Phillips Pan Head Screws, 2 - M4 Nylon Stop 

Nuts, PHS-203 Ultra Slim Swivel and Mounting Hardware. 

TOOLS NEEDED FOR MVM MODIFICATION (if required)

4 inch Mounted Bench Vise 

12 oz. Ball Pein Hammer 

Standard Tin Snips 

Standard Hacksaw

Small File

Dash Trim Tool (Part #SIT-104)

# 2 Phillips Screwdriver

T-20 Torx bit and Driver

9/32” Open End Wrench (for swivel)

Marking Pen

Start by removing the three (3) T-20 Torx screws toward the bottom of 

the glove box. Open the glove box and locate and remove three (3) more 

screws toward the top. Set the screws aside. Insert the Dash Trin tool (part 

#SIT-104) in between the radio bezel where it meets the dash molding on 

the right side releasing two (2) clips. Open the molding up enough to get 

to the exposed T-20 Torx screw.

Skip to Step 6 on the following page if you have not yet formed the 

bracket to fit your vehicle.

Remove the exposed T-20 Torx screw. Place the MVM over the hole and 

replace the T-20 Torx screw. Tighten down the MVM. 

Carefully reinstall the dash in reverse order securing all screws and clips 

to the bezel. Attach the face of the MVM to the section that is protrud-

ing out from the dash. Align the holes and attach the two pieces with the 

provided M4x8 Phillips Pan Head Screws and M4 nylon Locking Nuts. 

Use the #2 Screwdriver and 9/32” open end wrench to tighten.

 Install the included Ultra Slim Swivel #PHS-203 to your Multi Vehicle 

Mount or any other AMPs compatible device.

Your installation is complete

Install Mount Here

  

Note:

 The hole pattern on the face of the MVM maybe 

different then what is shown in the pictures.