Boss Audio Systems GT-100 사용자 설명서

Are the MIDI cables broken?

Try another set of MIDI cables.

Is the GT-100 correctly connected to the other MIDI 

device?

Check connections with the other MIDI device.

Do the MIDI channel settings of both devices match?

Make sure that the MIDI channels of both devices match (p. 44).

When you send messages from the GT-100, make 

sure the GT-100 is set to the settings appropriate for 

sending data.

Check the on/off status for transmission of program change messages 

(p. 44) and the settings for the controller numbers to be transmitted  

The data cannot be processed correctly due to the 

high volume of MIDI messages.

Reduce the volume of MIDI messages transmitted to the GT-100.
Reduce the tempo of the transmitting MIDI device.

Transmissions from the connected device have been 

interrupted. This message also appears when the 

power to the connected device has been turned off. It 

does not indicate damage.

Check to make sure no cable is disconnected and that there are no shorts.

Writing to the memory for storage of user data failed.

The unit may be damaged. Consult the nearest Roland service center.

The [EXP] pedal cannot be calibrated.

Confirm the calibration by carrying out the procedure once more (p. 36).
If the message continues to appear even after the calibration is correctly 

performed, it may indicate damage or malfunction. Consult your Roland 

dealer or contact Roland Service Center.

The knobs are locked.

Turn “KNOB LOCK” off (p. 41).

The “PREFERENCE” (p. 41) is set to “SYSTEM.”

If the preference is set to “SYSTEM,” the patch assignment and manual mode 

settings will be ignored. If you want to enable the settings of the patch, 

change the preference for the corresponding parameter to “PATCH”.

PEDAL FUNC IS PHRASE LOOP! The “PEDAL FUNC” (p. 32) is set to “PHRASE LOOP.”

If the phrase loop pedal function is set to “PHRASE LOOP,” the patch assign-

ment and manual mode settings will be ignored. If you want to enable the 

settings of the patch, set the “PHRASE LOOP PEDAL FUNC” to “OFF”.