Whirlpool ACE082XP1 사용자 설명서

Operating your air conditioner properly helps you to obtain the 
best possible results. 

This section explains proper air conditioner operation.

IMPORTANT: 

■

If you turn off the air conditioner, wait at least 3 minutes 
before turning it back on. This prevents the air conditioner 
from blowing a fuse or tripping a circuit breaker.

■

Do not try to operate your air conditioner in the cooling mode 
when outside temperature is below 65°F (18°C). The inside 
evaporator coil will freeze up, and the air conditioner will not 
operate properly.

NOTE: In the event of a power failure, your air conditioner will 
operate at the previous settings when the power is restored.

1. Set the Exhaust control. See “Exhaust Control (on some 

models).”

2. Set the Fan Control to desired setting. See “Fan Control” for 

your model.

3. Turn the Thermostat control to a mid-setting. See 

“Thermostat” for your model.

Set the Exhaust control to CLOSED for maximum continuous 
cooling. The Exhaust control set OPEN allows you to draw stale 
or smoky air from the room.

■

OPEN—to exhaust room air to the outside

■

CLOSED—to circulate room air

NOTE: The Exhaust control will function only when the Fan 
Control is operating.

Set the Fan control to the desired setting. When the air 
conditioner is operating at Low Cool, High Cool, or Turbo Cool, 
the fan circulates air continuously.

■

Turbo Cool—for maximum cooling

■

High Cool—for normal cooling

■

Low Cool—for sleeping comfort

■

Fan Only—to move air continuously without cooling

NOTE: Fan runs on Turbo speed only.

 

Turn the THERMOSTAT control to a mid-setting. Adjust the air 
conditioner's performance by turning the Thermostat control 
clockwise for maximum cooling. For less cooling, turn the 
THERMOSTAT control counterclockwise. Experiment to find the 
setting that suits you best.

Set the Fan control to the desired setting. When the air 
conditioner is operating at Low Cool, High Cool, Turbo Cool, Low 
Heat or Turbo Heat, the fan circulates air continuously.

■

Low Heat—for reduced heating

■

Turbo Heat—for maximum heating

■

Turbo Cool—for maximum cooling

■

High Cool—for normal cooling

■

Low Cool—for sleeping comfort

■

Fan Only—to move air continuously without cooling or 
heating

NOTE: Fan runs on Turbo speed only.

■

Power Saver—the fan runs only when cooling is needed. The 
fan stops circulating air when the room temperature matches 
the Thermostat control setting.

Since the fan does not circulate the room air continuously, 
less energy is used but the room air is not circulated as often. 
Use Power Saver when you are asleep or away from home.

NOTE: Fan runs on Low speed only.