Wayne-Dalton TORQUEMASTER 6100 사용자 설명서

다운로드
페이지 36
Tools Needed:
32
Tools Needed:
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your 
local yellow pages/business listings or go to the 
Find a Dealer section online at www.wayne-dalton.com
Side lock
Install the side lock on the second 
section of the door. secure the lock 
to the section with (4) 1/4”- 20 x 
11/16” self drilling screws. square the 
lock assembly with the door section 
and align with the square hole in the 
vertical track. The side lock should be 
spaced approximately 1/8” from the 
section edge.
IMPORTANT: sIDE lOCks MusT bE 
REMOVED OR MaDE INOPERaTIVE IN 
ThE uNlOCkED POsITION If aN 
OPERaTOR Is INsTallED ON ThE 
DOOR.
NOTE: after completing this step, 
continue with step 13 on
 page 15.
(4) 1/4”- 20 x 11/16” 
sElf DRIllING sCREWs
1/8”
Power Drill
7/16” socket 
Driver
Pull Rope
DO NOT INsTall Pull ROPEs 
ON DOORs WITh ElECTRIC 
OPERaTORs. ChIlDREN May 
bECOME ENTaNGlED IN ThE 
ROPE CausING sEVERE OR 
faTal INjuRy.
Measure and mark the jamb 
approximately 48” to 50” (1220 to 1270 
mm) from floor on the right or left side 
of jamb. Drill 1/8” pilot hole for No. 6 
screw eye.  Tie the pull rope to the No. 
6 screw eye and to the bottom bracket 
as shown.
WARNING
Power Drill
1/8” Drill bit
NO. 6 sCEW EyE
Pull ROPE
bOTTOM bRaCkET
Pull ROPE