Woodstock THE SHOP FOX D2677 사용자 설명서

 

2.. Loosen the belt tension lock knobs on the

side of the headstock (see

Figure.35).

3.  Locate the desired speed on the chart and

move the V-belt to the desired V-grooves

on the motor and spindle pulleys (see

Figure.36).

4.. Push the motor inward, and move the V-

belt to the right spot.

5.. Push the motor toward the back of the 

headstock. The motor support rod is spring 

loaded and will follow the motor. Tighten 

the lock knob when the right tension is 

achieved.

6.  Close the cover.

The Model W1669 and W1670 Radial Drill Press

has 5 speeds ranging from 550 to 3470 RPM.

To find your needed drilling speed and pulley 

combination, refer to the speed chart located 

under the belt guard; or go to

.Page.22 and 

refer to the 

Drill.Press.RPM.Chart.

Figure.35..Loosening lock knob.

Figure.36..Adjusting belt to desired speed.

Pushrod

-21-