White Rodgers 760-56 Flame Sensor 설치 설명서
To prevent electrical shock and/or equipment
damage, disconnect electric power to system at
main fuse or circuit breaker box until installation
is complete.
damage, disconnect electric power to system at
main fuse or circuit breaker box until installation
is complete.
Label all wires prior to disconnection when ser-
vicing controls. Wiring errors can cause improper
and dangerous operation.
vicing controls. Wiring errors can cause improper
and dangerous operation.
Following installation or replacement, follow
appliance manufacturers’ recommended instal-
lation/service instructions to insure proper
operation.
appliance manufacturers’ recommended instal-
lation/service instructions to insure proper
operation.
Printed in U.S.A.
PART NO. 37-5636A
9645
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MO 63123-5398
(314) 577-1300 FAX (314) 577-1517
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MO 63123-5398
(314) 577-1300 FAX (314) 577-1517
WHITE-RODGERS
760 Series
Electrodes
INSTALLATION INSTRUCTIONS
The 760 series electrodes are made in various configura-
tions to meet the specific requirements of different appli-
cations. Depending on electrode design, they may be
used for spark ignition, flame sensing or a combination of
both.
tions to meet the specific requirements of different appli-
cations. Depending on electrode design, they may be
used for spark ignition, flame sensing or a combination of
both.
Operator: Save these instructions for future use!
PRECAUTIONS
THESE CONTROLS MUST BE INSTALLED BY A
QUALIFIED INSTALLER.
QUALIFIED INSTALLER.
All wiring must conform to local and national electrical
codes and ordinances.
codes and ordinances.
Do not use on circuits exceeding specified volt-
ages. Higher voltages will damage control and
could cause shock or fire hazard.
ages. Higher voltages will damage control and
could cause shock or fire hazard.
Shut off main gas to heating system until installa-
tion is complete.
tion is complete.
CAUTION
!
These electrodes are not universal replacements. They
can only be used to replace the identical type in applica-
tions where it was originally installed by the equipment
manufacturer. If the electrode you are replacing is not the
same type number, contact the original equipment manu-
facturer (OEM) for a suggested replacement.
can only be used to replace the identical type in applica-
tions where it was originally installed by the equipment
manufacturer. If the electrode you are replacing is not the
same type number, contact the original equipment manu-
facturer (OEM) for a suggested replacement.
TYPICAL ELECTRODE ASSEMBLIES
WARNING
!