White Outdoor Two Stage Snow Blower 사용자 설명서

NOTE: If you’re replacing the friction wheel assembly 
as a whole, discard the worn part and slide the new part 
onto the hex shaft. Follow the steps above in reverse 
order to reassemble components. If you’re disassem-
bling the friction wheel and replacing only the rubber 
ring, proceed as follows:

6.  Remove the four screws which secure the friction 

wheel’s side plates together. See Figure 6-13.

7.  Remove the rubber ring from between the plates.
8.  Reassemble the side plates with a new rubber ring.
9.  Slide the friction wheel assembly back onto the hex 

shaft and follow the steps above in reverse order to 
reassemble components.

If unit is to be stored over 30 days, prepare for storage 
as instructed in the separate engine manual packed with 
your snow thrower.

Clean snow thrower thoroughly.

•

Lubricate as instructed in the Maintenance section 

•

of this manual.
Refer to engine manual for correct engine storage 

•

instructions.
Store the snow thrower in a clean, dry area.

•

When storing any type of power equipment in 

•

a poorly ventilated or metal storage shed, care 
should be taken to rustproof the equipment, 
especially springs, cables and all moving parts.

When reassembling 
the friction wheel as-
sembly, tighten each 
screw only one rota-
tion before turning the 
wheel clockwise and 
proceeding with the 
next screw. Repeat 
this process several 
times to ensure the 
plates are secured 
with equal force.