White Outdoor 31AH7Q3G190 사용자 설명서

13

The shave plate and skid shoes on the bottom of the 
snow thrower are subject to wear. They should be 
checked periodically and replaced when necessary. To 
remove the skid shoes, proceed as follows:

•

Remove the six carriage bolts, bell washers, and 
hex nuts which attach them to the snow thrower.

•

Reassemble new skid shoes with the six carriage 
bolts, bell washers (cupped side goes against skid 
shoes) and hex nuts. Make certain the skid shoes 
are adjusted to be level.

To remove shave plate, remove the carriage bolts, bell 
washers, and hex nuts which attach it to the snow 
thrower housing. Reassemble new shave plate, making 
sure heads of the carriage bolts are to the inside of the 
housing. Tighten securely.

•

Remove the plastic belt cover by removing the two 
self-tapping screws. See Figure 13.

•

Drain the gasoline from the snow thrower.

•

Tip the snow thrower up and forward so that it rests 
on its auger housing.

•

Remove the six self-tapping screws from the frame 
cover underneath the snow thrower.

•

Roll the front and rear auger belts off the engine 
pulley. See Figure 14.

•

Unhook the idler spring from the hex bolt on the 
auger housing. See Figure 14.

•

Back out the stop bolt until the support bracket 
rests on the auger pulley.

•

Lift the auger belt from the auger pulley, and slip 
belt between the support bracket and the auger 
pulley. Repeat this step for the front auger belt.

•

Replace the auger drive belts by following 
instructions in reverse order.

•

Follow the first four steps of the instructions for 
servicing the auger belts.

•

Pull the idler pulley up, and lift the belt off the 
engine pulley and friction wheel disc. See Figure 
15.

•

Back out the stop bolt until the support bracket 
rests on the auger pulley.

•

Slip the belt between the friction wheel and drive 
disc. Remove and replace the belt. Reassemble 
following the instructions in reverse order.