Whirlpool WTW4950XW 사용자 매뉴얼

Temperature Control senses and maintains uniform water 

temperatures by regulating incoming hot and cold water. 
Select a wash temperature based on the type of fabric 

and soils being washed. For best results and following the 

garment label instructions, use the warmest wash water safe 

for your fabric.  
 •  Warm and hot water will be cooler than what your previous 

washer provided.

•  Even in a cool water wash, some warm water may be 

added to the washer to maintain a minimum temperature.   

The following options may be added to most cycle.  

See “Cycle Guide” for additional details. 

This option can be used to automatically add a second 

rinse to most cycles.
FABRIC SOFTENER ADDED

This option must be set to “Yes” if using fabric softener  

during a cycle. 
ECOBOOST™ option 

The EcoBOOST™ option allows you to increase your 

energy savings on your wash cycles. When this option is 

used, the wash cycle will use slightly cooler wash water 

than the selected temperature. 

Use the Wash Cycle knob to select available cycles on 

your washer. See “Cycle Guide” for detailed descriptions of 

cycles.

Press to start the selected cycle; press again to pause the 

cycle and unlock the lid. 

NOTE: If the washer is spinning, it may take several  

minutes to unlock the lid. Press and hold 3 seconds  

to cancel a cycle.

The Cycle Status Lights show the progress of a cycle.  

At each stage of the process, you may notice sounds or 

pauses that are different from traditional washers.

  When the START/Pause/Unlock button is pressed,  

the washer will first perform a self-test on the lid lock  

mechanism. You will hear a click, the basket will make  

a slight turn, and the lid will unlock briefly before locking 

again. 

  Once the lid has locked the second time, the washer  

will use short, slow spins to estimate the load size.  

These sensing spins may take 2 to 3 minutes before  

water is added to the load and you may hear the hum 

of these spins. If the sensing light is on, then washer is 

working properly. You will hear the motor turn the basket 

in short pulses to thoroughly wet the load. The washer  

will then move the load briefly, pause to allow water 

to soak in to the load, and resume adding water. This 

process may repeat until the correct amount of water  

has been added for the load. You may also hear water 

flowing through the dispenser, adding detergent to the 

load. 

Avoid opening lid during sensing. The sensing 

process will start over when the washer is restarted.  

The sensing light may also come on during the Soak  

and Wash portions of the cycle. This is normal. 

  You will hear the motor and washplate moving the load. 

Unlike traditional washers, the load is not covered with 

water. Low-water cleaning means concentrated cleaning. 

Rather than diluting detergent as done in an agitator-style 

washer, this washer delivers the detergent directly to the 

soils. The motor sounds may change at different stages 

in the cycle. The wash time is determined by the selected 

soil level.