B&K AVR202 Plus 사용자 설명서

13259 0303 

33

Usually these settings may be left set to the factory defaults. However, theses settings allow you to correct or 
reduce the various tonal errors that occur during reproduction of audio in a home theater. 
 
The room equalization menu allows for two types of adjustments. 
 

1) A notch filter that allows you to ‘Notch’ or reduce the accentuated bass created in a room with multiple 
speakers (see Setting up the notch filter). 
 
2) Variable bass and treble controls allow you to configure a default ‘Variable EQ’ setting that best suits your 
listening room needs.  

 

 

From Remote 

From Front Panel 

Action 

1 

À(PAUSE) or  §(STOP)  . (UP) or - (DOWN) 

move to Room Equalization 

2 

SEL or ENTER 

↵ (ENTER) 

activate SETUP EQUALIZATION 

 
Using the test tone generator - your receiver has a low frequency sine wave generator (20 to 300 Hz) available 
as an aid in determining the most offensive frequency to notch. Usually this test tone generator will be used with 
the aid of an SPL meter in a similar fashion as that described in Setup Speaker Levels. The tone generator may 
also be used to show up any mechanical room vibrations that should be reduced or eliminated. While active, the 
generator has adjustable frequency and three selectable output levels.   

 

ROOM EQUALIZE

TEST    100.0 hz

 

TEST TONE OFF