B&K AVR202 Plus 사용자 설명서

13259 0303 

39

Usually these settings may be left set to the factory defaults. However, your receiver allows ‘fine tuning’ how your 
receiver operates after the selection of an input source. Make sure you are in the SETUP MENUS and your 
remote is in B&K mode. 

 
 

 

From Remote 

From Front Panel 

Action 

1 

À(PAUSE) or  §(STOP)  . (UP) or - (DOWN) 

move to Inputs 

2 

SEL or ENTER 

↵ (ENTER) 

activate SETUP INPUTS 

 
Select input -  

 

From Remote 

From Front Panel 

Action 

1 

¶

(REW) or

 •

(FF) 

VOLUME KNOB 

select  source 

 
Set the favorite audio listening mode - Your processor provides for 4 audio listening modes Mono, Stereo, 
Surround and DVD Audio (Optional) (See AUDIO MODES). You may set a default audio mode and speaker 
selection (excluding selection 0 ‘Headphone’, or selection 9 ‘LtRt’) for each of your input sources. When a source 
is selected from the remote control or front panel, the audio mode will automatically be set to use this favorite 
mode and speaker selection. Note that DVDA mode can only be selected if that input is designated as the DVD 
audio input below and the internal DVDA switch has been set (see DVD Audio using the Coax digital inputs under 
MAKING THE CONNECTION). 

SETUP  INPUTS

SYSTEM SETUP

 

SETUP       DVD