Presonus Audio electronic 26x26 FireWire Recording System 사용자 설명서

 

26 

 
4.1 Expanding Your I/O 
You can easily connect additional microphone preamplifiers to expand your inputs and 
outputs on your FireStudio via ADAT/SMUX optical light pipe connectors.   

•  The DigiMax FS can connect to the FireStudio using 88.2k and 96k sample 

rates via dual SMUX optical ADAT using 2 standard optical cables audio.   

•  If you are recording with sample rate settings of 44.1k or 48k, you can connect 

2 DigiMax FS’ to the FireSTudio for 16 additional preamp inputs and line 
level outputs.  

 

Note that ADAT channels 9-16 can only be assigned within your recording 
software (DAW).  You cannot mix or route the Auxiliary ADAT channels 9-16 
in the FireStudio Control Console. Each DigiMax FS or other digital preamp 
will connect with 1 optical cable at 44.1k or 48k. 

•  You can also further expand your FireStudio by connecting to the Digital 

SPDIF I/O.  Two PreSonus Eureka channel strips can be connected using the 
Eureka’s AD192 digital output card. Simply connect the SPDIF output on the 
Eureka to the SPDIF input on the FireStudio for two additional microphone 
preamplifiers. 

 NOTE:  Any time you connect an external digital device you must make sure your 
Master and Slave Clock Source settings are appropriate.  Only 1 device can be the 
Master device that will generate clock.  Every other device connected must be 
Slaved to the Master device.  You must also make sure that Sampling Rate is set 
the same for each connected device.  See section 3.4 Hardware Settings above.