Panasonic Attune II 설치 가이드
36
Troubleshooting
Check the following before requesting repair.
Consult your sales shop if these measures do not resolve a problem, if symptoms not listed here occur, or if you have a question
related to engineering.
Consult your sales shop if these measures do not resolve a problem, if symptoms not listed here occur, or if you have a question
related to engineering.
Symptom
Cause/solution
Reference pages
No communication between
the order post, Belt Packs
and All-In-One Headsets is
possible.
the order post, Belt Packs
and All-In-One Headsets is
possible.
p Is the power cord connected securely to the AC input terminal
of this unit and to the power outlet?
¬ Check whether it is connected.
P.24
Paging between the store
personnel is possible, but
talking with the customers
using the order post is not
possible.
personnel is possible, but
talking with the customers
using the order post is not
possible.
p Have the microphone input and speaker output of the order
post been connected properly?
¬ Check whether it is connected properly.
P.25
An echo is heard from the
earphone of the headset
when an individual is talking
into the headset microphone.
earphone of the headset
when an individual is talking
into the headset microphone.
p The speaker and microphone for the order post may not have
been installed correctly.
¬ Check that the speaker and microphone are placed at a
sufficient distance from each other, and anchor them securely
so that any vibrations are absorbed.
so that any vibrations are absorbed.
WX-CS460
Operating
Instructions
p The input and output audio levels may have been set too high.
¬ Lower the audio input and output levels (OUT MIC/OUT SP) for
the order post to the appropriate level. (Feedback noise can be
prevented by selecting a setting that lowers the audio input level.)
prevented by selecting a setting that lowers the audio input level.)
Operating
Instructions
<Setup
Instructions>
p The echo canceller is off or its level is low.
¬ Set the echo canceller to the appropriate level.
(The default setting is “MID”.)
Operating
Instructions
<Setup
Instructions>
A lot of noise is heard from
order post.
order post.
p DNR is OFF or its level may be low.
¬ Set the DNR to the appropriate level.
(The default setting is “MID”.)
Operating
Instructions
<Setup
Instructions>
There is no reaction even
when the buttons on the
touch panel are touched.
when the buttons on the
touch panel are touched.
p Is the touch panel dirty?
¬ Clean the touch panel.
If there is no improvement even after it has been cleaned, adjust
the touch panel.
the touch panel.
P.10
When one of the buttons on
the touch panel has been
touched, another button
reacts instead.
the touch panel has been
touched, another button
reacts instead.
p The touch panel must be adjusted.
¬ Adjust the touch panel.
Operating
Instructions
<Setup
Instructions>
Communication breaks up or
it is hardly possible to hear
what is being said.
it is hardly possible to hear
what is being said.
p Are the All-In-One Headsets or Belt Packs too far away from
the Center Module, or are there any obstructions such as
concrete walls or metal devices between the Center Module
and the All-In-One Headsets or Belt Packs?
concrete walls or metal devices between the Center Module
and the All-In-One Headsets or Belt Packs?
¬ Contact the store where you purchased this unit, and move this
unit to a location where there are no obstructions around it.
–––
No communication with the
cameras is possible.
cameras is possible.
p Have the cameras been registered in the Center Module?
¬ No communication with the cameras is possible if the cameras
have not been registered. Register the cameras that are to be
connected.
connected.
Operating
Instructions
<Browser Guide>
Nothing happens even when
operations are performed
correctly; or the operations
are performing incorrectly.
operations are performed
correctly; or the operations
are performing incorrectly.
p This unit may not be working properly.
¬ Press the reset button on the side panel of this unit using a fine-
tipped object. (The settings, etc. will not be cleared.)
P.13