Netgear LG6100D 사용자 가이드
Set up a Virtual Private Network (VPN)
118
To use NETGEAR ProSAFE to set up a VPN client:
1. Download the trial version of NETGEAR ProSAFE VPN client (VPNG01L/VPNG05L
Professional Software Version 5.14.003) and install it on the Windows computer.
NOTE: This software is available here:
2. Launch the VPN client software.
3. In the left pane, select Global Parameters.
4. Specify the following settings:
Lifetime (sec):
•
Authentication (IKE): Enter 3600, 1800, 28800.
•
Encryption (IPSec): Enter 1200, 1200, 28800.
Dead Peer Detection (DPD):
•
Check interval: Enter 30.
•
Max. number of retries: Enter 5.
•
Delay between retries: Enter 15.
Miscellaneous:
•
Retransmissions: Enter 5.
•
X-Auth timeout: Enter 60.
5. Enter the gateway settings:
Click Configuration > Wizard.
Select A router or a VPN gateway.
Enter the IP or DNS address of the gateway to connect to.
Enter the pre-shared key.
Enter the IP private (internal) address of the remote network. (This is the router LAN
IP you are connecting to, for example 192.168.0.0.)
Click Next.
Review the settings are correct and then click Finish.
6. In the left pane, select Gateway, and click the Authentication tab.