BMW 2010 328i Sedan 사용자 매뉴얼

다운로드
페이지 274
 221
Display via iDrive
1.
"Vehicle Info"
2.
"Vehicle status"
3.
"Engine oil level"
Possible messages
>
"Engine oil level OK"
>
"Measurement not possible at this time."
>
"Measuring engine oil level...":
This can take about 3 minutes if the car is at 
a standstill on a level surface and the engine 
is running, and about 5 minutes while the 
car is moving.
If engine oil was added, it may take up to 
30 minutes to obtain an oil level reading.
>
"Engine oil level below minimum. Add 1 
quart!"
Add engine oil as soon as possible, but no 
more than 1 US quart/1 liter, refer also to 
Adding engine oil below.
If the oil level is below the minimum value, 
add engine oil immediately to avoid engine 
damage.
>
"Engine oil level too high! Have this 
checked."
Too much oil will harm the engine. 
Have the vehicle checked without 
delay.
<
>
"Measurement inactive. Have this 
checked."
Do not add engine oil. You can continue 
your journey. Note the newly calculated dis-
tance remaining to the next oil service, refer 
to page
. Have the system checked as 
soon as possible.
Adding engine oil
Add a maximum of 1 US quart/1 liter of engine 
oil no earlier than when a corresponding mes-
sage appears on the Control Display or, if the 
car has a diesel engine, when the oil level has 
dropped to just above the lower marking on the 
dipstick, refer to page
Add oil within the next 125 miles/200 km; 
otherwise, the engine could be dam-
aged.
<
Keep oils, greases, etc. out of the reach of 
children and comply with the relevant 
warnings on the containers. Otherwise, health 
hazards may result.
<
Oil change
Have oil changed only at your BMW center or at 
a workshop that works according to BMW 
repair procedures with correspondingly trained 
personnel.
Oil types
Do not use oil additives as this could 
result in engine damage.
<
Online Edition for Part no. 01 41 2 603 048 - © 08/09 BMW AG
Online Edition for Part no. 01 41 2 603 048 - © 08/09 BMW AG