Lorex DIGITAL VIDEO SURVEILLANCE RECORDER LH010 ECO BLACKBOX SERIES 사용자 설명서

41

Using the Main Menu

The Alarm tab allows you to 
configure Motion Detection 
settings.

Configure motion settings to determine 
the area you wish to monitor for motion 
events, and the outcome if a motion 
event occurs.

Select the Motion tab.

Configure the following:

• Channel: Select the channel you wish to 

configure.

• Enable: Select Enable or Disable to 

activate or deactivate motion recording.

• Area: Click the Setup button to configure 

the area of the screen that detects motion. 

• Sensitivity: Select motion sensitivity. The 

greater the number, the greater the 
sensitivity.

• Show Message: Select the checkbox if you 

want the system to display a system 
message when an alarm triggers.

• Buzzer: Select the duration the system 

will "beep" when motion is detected. Or 
select OFF to disable the "beep" during 
motion events.

• Send Email: Select the checkbox if you 

want the system to send email 
notifications if an alarm triggers. Email 
notifications must be configured.

• Record Channel: Select the channel you 

wish the DVR to record during motion 
recording.

• Full Screen: Select the Full Screen check 

box so that the system goes into full screen 
mode when motion is detected.

• Post Recording: Enter the post recording 

duration (the time the system continues to 
record after a motion event occurs).

Click Apply to save your settings.

Drag mouse cursor 
over desired area

Click and drag the mouse cursor to configure motion 
detection areas. Motion detection is enabled in red areas 
and disabled in transparent areas. Right-click to exit.