High End Systems Technobeam 사용자 설명서

4-6

Technobeam

®

 User Manual

11. If the flags are closed, repeat this procedure.

12. If the shutter is open and no light is exiting the fixture, the lamp is off.  

(The lamp is automatically turned off after a period of no activity.)  In 
that case, turn the fixture OFF, wait a few minutes, then repeat the 
procedure in the section titled “Turning on the Lamp” on page 4-4.

1.

Use the <Up> and <Down> arrow keys to navigate to the PAN 
construct.

2.

Use the <Up> and <Down> arrow keys to move the mirror to the 
desired location, then press <Enter>.

3.

Use the <Up> and <Down> arrow keys to navigate to the TILT 
construct and press <Enter>.

4.

Use the <Up> and <Down> arrow keys to move the mirror to the 
desired location, then press <Enter>.

1.

Use the <Up> and <Down> arrow keys to navigate to the LTOC (control) 
construct.

2.

Press <Enter>, then use the <Up> and <Down> arrow keys to select 
IDX

. 

3.

Press <Enter> to accept your selection, then use the <Up> and <Down> 
arrow keys to navigate to the LTO construct.

4.

Press <Enter>, then press the <Up> or <Down> arrow keys to select any 
litho pattern (except L  1, the open position).  

5.

Press <Enter> to accept your selection, then use the <Up> and <Down> 
arrow keys to navigate to the FCUS construct.

6.

Press <Enter>, then use the <Up> and <Down> arrow keys to bring the 
litho into sharp focus.

7.

Press <Enter> when you are finished focusing the fixture.

1.

Use the <Up> and <Down> arrow keys to select COLC.

2.

Press <Enter>, then press the <Up> and <Down> arrow keys to select 
RND

 (random color selection).

3.

Press <Enter>.  The color wheel spins and stops on a random position, 
pausing for a length of time you will set in the next section.