Extech Instruments Easy View Digital Light Meter EA31 사용자 설명서
EA31 V2.0 06/06
4
Operation
Power ON or OFF
Press the button to turn power on or off.
Units of measure
Press the lux / fc button to select the unit of measure. “fc” or “lux” will appear in
the display.
the display.
Light sensor
1. The light sensor is attached to the meter with a coiled cable which allows
placement of the sensor up to approximately 3 feet from the meter.
2. The light sensor is a silicon photo diode and resides under the white domed
lens.
3. To protect the lens from scratches, keep the protective cap on the sensor
whenever the unit is not in use.
4. The back of the sensor has a tripod mounting hole.
Taking measurements
1. Remove the protective cap from the sensor.
2. Place the sensor in a horizontal position at the measurement location.
3. Read the light level on the display. If the light measurement is out of range an
“OL” indication will appear on the display. If the ‘OL’ appears, select a higher
range by pressing the RANGE button.
range by pressing the RANGE button.
MX MN Function
1. Press the MX/MN button once to put the meter in MX/MN mode. The meter
will now display the highest reading that occurs while the function is enabled.
The “MAX” icon will appear in the display.
The “MAX” icon will appear in the display.
2. Press the MX/MN button again to display the lowest reading that occurs while
the function is enabled. The “MIN” icon will appear in the display.
3. Press MX/MN again to toggle between the MAX and MIN readings.
4. To exit the MX MN mode and return to the normal real time display, press
and hold the MX/MN button (2 seconds) until the MAX and MIN icons
disappear.
disappear.
Data Hold
Press the HOLD button to freeze the displayed reading. The '
H
' hold icon will
appear on the display. Press the HOLD button again to return to normal
operation.
operation.