Wacom Intuos 사용자 설명서

     Page  118

2.

  Move your Intuos Pen across the active area of the tablet; the screen cursor should 

move in the corresponding direction on your monitor.  Press the pen tip against the tablet surface.  
The status LED on the tablet should turn from orange to green.  Now, without applying pressure to the 
pen tip, press the side switch.  The status LED should again change from orange to green.  Turn the 
pen over and press the eraser against the surface of the tablet; the status LED should change from 
orange to green.  If not, you may have a defective pen or tablet.  See 

Intuos USB tablets require Windows 98 or 2000.  Many PCs that shipped with Windows 95 have the USB 
port disabled in the BIOS.  If you upgraded to Windows 98 or 2000, verify that the USB ports are enabled 
in the BIOS and that all necessary system software has been installed.  Refer to your system 
documentation or contact your system manufacturer for information on enabling USB support for your 
computer.

Run the USB Ready utility located on the Intuos CD-ROM to check if your system is USB ready.

If your system is not USB ready, correctly configure your USB port and install the necessary USB system 
software, then restart your computer.  The N

EW

 H

ARDWARE

 F

OUND

 dialog should appear and you can 

continue with the Intuos installation.

Always be sure your tablet is plugged directly into your computer or into a powered USB hub.