Uniden BCD996T 사용자 매뉴얼

124

For example: If the Dangerous Road location is toward the Northeast and you are 
driving in that direction, then choose NE (45°)

If you know you will be driving on a road which has many curves to that site center, 
choose All Range which will trigger the alert regardless of direction as long as 
the other requirements (range, speed) are met.

If you travel in a Northeast direction and do not travel either side of a northeast line 
by up to 22 degrees, the alert system will function.

 

F

 

Choose from 0, through 100 MPH in 5 MPH steps or 

the equivalent in KPH for metric usage. If you set it to 0 MPH, the alert beeps 
every time the scanner exceeds the range.

Press [GPS], to switch the scanner to a GPS display mode. In this mode, you can 
see location information as well as information about your position relative to the 
selected POI. The third line of the screen shows OFF if no POI is selected.

Rotate the Scroll Control to select different POI’s.

Press 

F

 + [GPS] to toggle the Display mode in order.

GPS DATA Display

ETA Display

Clock Display

Car One is driving south. Car Two is driving 
east. Car One is alerted since the Latitude 
and Longitude of the Dangerous Road is 
programmed as well as the Range and the 
Direction. When all three data sets are met, 
the alert sounds. Since Car Two is going 
east, no alert sounds as the Direction is not 
met.