Uniden BCD996T 사용자 매뉴얼

60

You are given a last opportunity to keep the factory programmed data when you 
see the question:

 Yes=”E”/”No= ”.”

If you do not say Yes, the scanner is totally empty.

You can connect your scanner, by means of the 
supplied cable, to a personal computer to download 
data from the computer to the memory of the scanner. 
Before you proceed, you must first set the scanner’s 
communications speed as described in the previous 
section. In addition you will need a copy of Uniden 
Advanced Scanner Director software. You can 
download the software from http://www.uniden.com in 
the Customer Service Downloads link. 

Important: Start with a high baud rate setting. If, during transfer, you get an error 
message, reduce the setting and start again until you get reliable, complete 
transfer of data.

If you use a PC to control the scanner, and you change the scanner’s volume or 
squelch setting using the PC, the scanner ignores the front-panel control’s current 
setting. However, if you later change the volume or squelch setting using the 
front-panel control, the scanner uses the control’s setting (i.e. the scanner pays 
attention to the last method used).

Using the scanner in a cloning setup lets you transfer programmed data directly 
from a source or master BCD996T to a target or slave BCD996T. Wired cloning 
between other models to the BCD996T is not possible.

[MENU] 

 

 Wired Clone

 

F

 

 Master or Slave (select one as the master and one as the slave)

To clone (transfer) data directly from one BCD996T scanner to another BCD996T 
scanner, you must first connect the scanners to each other using the included 
connection cables and a DB9 null modem adapter and for the rear port, a DB9