Uniden BCD996T 사용자 매뉴얼

67

[MENU] 

 Program System 

F

 

 New System 

F

 

Then, select the system type:

 — Motorola Type I systems

 — Motorola Type II and APCO 25 systems

 — EDACS Wide and Narrow systems

 — EDACS SCAT systems

 — LTR Systems

The scanner creates an empty system with a default name of System n x. Note 
that “n” is a number that increments as you add new systems. The “x” on the right 
side of the display is M for Motorola system, E for EDACS systems, and L for LTR 
systems. After creating the system: 

1.

Set the system-level settings in “Programming System Settings” that apply to 
the type of system you selected.

2.

Set up at least one site for the system as described in “Programming Sites” on 
“Programming Sites” on Page 76.

3.

To scan specific channels, create one or more channel groups with channels 
as described in “Programming Channel Groups.”

Throughout the following sections, you will notice a heading on the right, such as 
MECLS in the next section. This helps designate the system types to which the 
section applies. In this section, the instructions apply to M (Motorola), E (EDACS 
Wide/Narrow), C (Conventional), L (LTR), and S (EDACS SCAT).

Each system name can be up to 16 characters. Abbreviate as necessary to fit. For 
Motorola and EDACS Wide/Narrow systems, the system name only appears in the 
scanner menu’s Program System listings. It is not shown during scanning. For 
other systems, the system name alternates with the Channel group when the 
scanner stops on a channel.

The default system names include the following letter in the 16th position to 
indicate the system type: M = Motorola; E = EDACS; L = LTR; C = Conventional;