Uniden BCD996T 사용자 매뉴얼

80

 

F

 

 Select a site 

F

 

 

F

 

 Select from the following choices

 

then press

 

F

 — the system is scanned when its quick key is enabled.

 — the system is locked for this session.

 — the system is not scanned.

[MENU] 

 Program System 

F

 

 

Select a trunked system 

F

 

 

 

F

 

 

Select a site 

F

 

 Set Hold Time 

F

This setting controls how many seconds the scanner looks at a site before moving 
to the next unlocked site or system. Using the number keypad, enter a value from 
0-255, then press 

F

 to save the setting.

• If the scanner cannot detect a control channel on an EDACS or Motorola 

system, it immediately moves to the next site or system. The scanner always 
scans LTR or SCAT systems for at least 1 second to check for current activity.

• If you select 0 and the control channel is received, the scanner stays on the 

system for a minimal time (only long enough to check current system activity).

• The default setting is 2 seconds for each system.

• The scanner moves to the next system after the hold time expires, any current 

transmission ends, and the channel delay time expires.

In order for the scanner to scan Motorola VHF and UHF sites, you must enter 
parameters that allow the scanner to determine the frequencies in use by the 
system. This information is normally available at the same source where the other 
system information is found.

[MENU] 

 Program System 

F

 

 

Select a trunked system 

F

 

 

 

F