Vertical Edge 120 사용자 설명서

 

Edge 120 Digital Executive Telephone User Guide 

Page 23

When you initiate an intercom call, you can use Forced Intercom Tone 
Ringing to cause the called telephone to ring. After a Voice Announce 
connection has been established to an extension, you may change the 
alert signal at that extension from Voice Announce to Tone Ring.  

1.  Establish an intercom call to an extension in Voice Announce 

mode (Hands-free or Private). Your telephone will display: 

VOICE CALL  xx 

 msg 

2. Press 

 to change the alert signal at the called extension from 

Voice Announce to Tone Ringing.  Your telephone will display: 

CALLING STA 10 

  cbck  msg   

3.  A Tone Ringing alert signal is sent and continues at the called 

extension until it is answered. 

4.  If your call remains unanswered, you may dial 

 again to return 

to Voice Call Announce mode. 

You may place any outside line on System Hold by pressing the 

HOLD 

button.  When you place a line on System Hold, the green lamp for 
that line will flash at the I-Hold rate. I-Hold Indication allows you to 
distinguish easily between a call you placed on hold at your telephone 
and calls placed on hold at other telephones. The green lamp 
indicates that this is your holding line. The same system hold line will 
flash the red lamp at all other extensions. 

1.  While on a line, the green lamp for that line is I-Use flashing 

(double wink rate). 

2. Press 

HOLD. The green lamp now flashes at a slow rate and the 

call is placed on System Hold. 

 

Also see Hold Key Lamp Indicators on page 36.