United States Stove 24A 사용자 설명서

Page 14

USSC

18. Installing steel smoke shield. Two (2) holes are

provided above each corner of the feed door.
Slide the two (2) bolts, supplied in the parts bag,
into the holes. Next, place the two (2) clips pro-
vided onto each bolt and then attach the two
(2) nuts on each bolt. Before tightening the bolts
and nuts securely, slide the smoke shield up un-
der the clips, lining them with the slots in the smoke
shield. Tighten the (2) bolts and nuts. (NOTE: The
smoke shield should be able to swing back and
forth.) The smoke shield will help prevent smoke
back puffing if you have a lazy flue.

17. To install Feed Door handle, insert handle into the

door then attach with the 1/2-13 nut and washer
provided. Tighten nut against the backside of
the door then back it off approx. 1/4 turn or until
handle moves freely.

(Follow these instructions

for ash door handle installation.)

ASSEMBL

ASSEMBLY ILL

Y ILL

Y ILLUSTRA

USTRA

USTRATIONS

TIONS

18. Find the Feed Door Latch shown in the parts box.

Install with the 1/4-20 bolts and nuts provided.
Adjust the latch so that the door seals properly.
(The ash door latch shall be assembled in the same
manner using the ash door latch.)

19. To install the dampers on the doors, screw the

damper up onto the 1/2-13 carriage bolt pro-
vided. Then screw the damper and bolt into the
door until the bolt protrudes the rear of the door
so that a nut can be attached. Tighten the nut.