Uniden UDW-10003 사용자 설명서

18

None of the buttons on the 

receiver respond when I 

press them.

Resetting the receiver.

-

If the video seems to lag and or the audio sounds weak, the camera and the receiver do not have a 
strong, clear signal between them. There are several causes for a weak signal:

The camera might be too 

far from the receiver.

Adjust the antennas on the receiver and the camera. Often, changing 

the angle of the antenna can improve the signal strength.

Try moving the camera closer to the receiver.

-

-

The battery in the camera 

or receiver may be low.

Make sure the batteries in the camera and receiver are fully charged. 

There may be too many 

obstacles between the 

camera and receiver.

Adjust the antennas on the receiver and the camera.

Remove as many obstacles from the signal path as possible, 

especially reinforced concrete walls and any large metal objecs that 

might reflect the signal. 

Avoid placing the camera and receiver where the signal path crosses 

a high-traffic area or body of water. For example, place the camera 

on the same side of a hallway as the receiver or mount the camera at 

least 7 feet up.

Relocate the camera and receiver so that there is a clear line of sight 

between them.

Try moving the camera closer to the receiver.

-

-

-

-

-

Weak signal and video performance
The video performance is directly affected by the signal quality. As the signal weakens degrades, 
the amount of data transferred decreases, and the video frame rate goes down. The table below 
shows a breakdown of the performance you can expect at the different levels of signal quality.