Uniden EXI7926 사용자 매뉴얼

If your phone is not performing to your expectations, please try these simple steps
before calling Uniden Customer Service at (800) 297-1023.

The status light won't come on
when the handset is placed in
the base unit.

The audio sounds weak and/or
scratchy.

Can't make or receive calls

The handset doesn't ring or
receive a page.

The Caller ID message 
disappears.

• Make sure the AC adapter is plugged into the

base unit and wall outlet.

• Make sure the handset is properly seated in

the base unit.

• Make sure the charging contacts on the hand-

set and base unit are clean.

• Make sure that the base unit antenna is in a

vertical position.

• Press            on the handset to eliminate 

background noise.

• Move the handset and/or base unit to a 

different location away from metal objects or
appliances and try again.

• Check both ends of the base unit telephone

line cord.

• Make sure the AC adapter is plugged into the

base unit and wall outlet.

• Disconnect the AC adapter for a few minutes,

then reconnect it.

• Place the handset back on the charging cradle

for a few seconds. The 

status LED will blink

indicating that the security code has been
reset.

• The battery pack may be weak. Charge the 

battery on the base unit for 12-15 hours.

• The handset may be too far away from the

base unit. 

• Place the base unit away from 

appliances or metal objects.

• Place the handset back on the charging cradle

for a few seconds. 

• The 

status LED will blink indicating that the

security code has been reset.

• The handset was picked up before the second

ring.

• The call was placed through a switch board.
• Call your local telephone company to verify

your Caller ID service is current.

chan

EXI 7926 H1  99.8.23 11:33 AM  Page 43