Powermatic 3-Roll Powered Stock Feeder PF3-JR 사용자 설명서

 

16

1.  Position the Stock Feeder so that the axis of 

the saw blade lines up between the center 
roller and infeed roller. See Figure 18. This 
will allow the Stock Feeder to grip the offcut 
of the workpiece as it leaves the blade. 

2. Rotate the Stock Feeder so that the 

direction of feed is angled slightly toward the 
fence by approximately 3/16” (5mm); that is, 
the outfeed roller should be slightly closer to  
the fence than the infeed roller. See Figure 
18. 

1.  Mount the stock feeder on a jointer so that 

all rollers are over the outfeed table, as 
shown in Figure 19. 

2.  The infeed roller should be approximately 

3/16” away from the lip of the outfeed table 
at the cutter area. See Figure 19. 

3. Rotate the Stock Feeder so that the 

direction of feed is angled slightly toward the 
fence by approximately 3/16” (5mm); that is, 
the outfeed roller should be slightly closer to  
the fence than the infeed roller. See Figure 
19. 

If more space is needed between rollers, for 
example when feeding a curved workpiece, the 
center roller can be removed from the Stock 
Feeder. To remove the roller, loosen and 
remove the two socket head cap screws (Figure 
20) with a 5mm hex wrench and pull the roller 
off the shaft. 

  Before performing any 

maintenance on the Stock Feeder, 
disconnect its plug from the electrical 
supply. Also disconnect the auxiliary 
machine from the electrical supply. Failure to 
comply may cause serious injury. 

If the power cord is worn, cut, or damaged in 
any way, have it replaced immediately. 

The rubber rollers should be kept clean of 
grease, sawdust and other debris. Use a soft 
cloth with soap and water to wipe down the 
rollers. DO NOT use a solvent on the rubber 
rollers.