Peugeot ELYSEO 125 사용자 설명서

Lighting and signalling

Lighting and signalling equipment in good working condition
is essential for safety.
Check the various lamps from time to time before
starting and when using your scooter to make sure
that they are working as they should.

- Lamp characteristics

Headlight/Diplight .................. H4 60/55W P43T38
Rear light and brake light ........... P 21/5W BAY15d
Turn signal lights ............................. R10W BA15S
Speedometer lighting ........... W1,2W T5 (no base)
and arning lights .................. W1,2W T5 (no base)
Number plate light ................................. W5W(T10)
Side lights ............................................. W5W(T10)

All lamps are 12 volts

See your dealer or distributor immediately if one of the
lamps is not working properly.

- Changing the bulbs

FRONT :

Headlight :

- Remove the 4 screws from the front panel
- Tip the fairing forward
- Remove the 4 headlight fixation screws
- Change the bulb

To adjust the headlight : unclip the container in the
bottom of the LH side glove compartment and turn the
adjustment screw in order to set the vertical
orientation.

Indicators :

- Remove the screw and the lens
- Change the bulb

REAR :

Rear light :
- Remove the 2 screws and the lens

- Change the bulb

Indicators :

- Remove the screw and the lens
- Change the bulb

NUMBER PLATE :

- Remove the screw
- Remove the 2 support screws from the bulb holder
cover
- Change the bulb