Peugeot ELYSEO 125 사용자 설명서

Hydraulically controlled

disk brake

(Frequency : see maintenance manual)

For your SAFETY, PEUGEOT recommends that you :

- Monitor operation of your FRONT and REAR

brakes.

- Have adjustment and maintenance operations

performed by a PEUGEOT dealer whenever action
proves to be necessary

- Use PEUGEOT original parts only.

The hydraulic circuit is filled with fluid in compliance with
the DOT3 or DOT4 standard. PEUGEOT uses LOCKHEED
D55.

- The fluid level in the hydraulic control
- The circuit seal
- The state of the brake pads

Control the braking efficiency.
If the brake control appears to be «spongy» when the brake
is actuated, take your scooter to your dealer for maintenance
PEUGEOT.

- Braking and parking

Good coordination between the throttle and the FRONT and
REAR brakes is very important.

- Reduce your speed by allowing the throttle to return
- Pull on the rear and front brakes

Caution

Braking is less efficient if you only use one brake.
Excessive braking may lock a wheel and make you lose
control of your vehicle!
When descending a steep gradient, cut back the
throttle completely and use both brakes to reduce
your speed and maintain control of your machine.
Avoid using the brakes continuously, overheating will
reduce braking efficiency and may cause an accident.

- Adjusting the rear brake *

The brake clearance is the distance that the lever can
move before starting to actuate the brake .
Adjusting the clearance
Clearance : 10 to 20 mm measured at the end of the lever.

- Adjustment nut
- To increase clearance loosen
- To reduce clearance tighten

Brake wear sector

- Reference mark
- Arrow

If the arrow faces the mark when the brake is actuated
fully, the brake blocks must be replaced.

* According to the model

20 mm