Omron BU1002SW 사용자 설명서

31

2. Installation and connection

After you finish connecting devices to the unit, make sure the backup function operates properly.

Check that the Battery Mode is performed normally according to the following procedure.

(This operation check simulates a power failure by disconnecting the AC input plug from a wall outlet.)

The beeper sounds and the current settings are displayed on the LED.

After 5 secounds, the self-diagnostic test is performed in Battery Mode for approximately 10 seconds.

When the self-diagnostic test finishes successfully, switching to AC output from commercial power is per-
formed and the the display below is shown.

(If the battery voltage is low, the self-diagnostic test is not performed and the operation starts immediately,
using output from commercial power.)

(Including devices connected to the AC outlet of your PC.)

Operate the devices in a way in which abrupt power stop
does not damage the connected devices, data, etc.

Are they in the same status as shown below?

If the same as the one shown above:

➜ The operation is normal. Proceed to (4).

If not the same as the one shown above:

➜ The operation is abnormal. One of the cases described in "4. Dis-

play and beeps when there is an equipment failure" of "3-3 Inter-
preting a beep and displays" on page 39 must apply.
Take necessary measures and then proceed to (4).

The UPS enters Battery Mode.

Status indicator

Description

Power switch “ON”

Operating normally

Status indicator

Beep

Power supply output receptacles

None

Outputs power (connected devices are powered)

-

バッテリ

 交換

バッテリ

 増設

ブザー停止/テスト

電源出力

バイパス

運転

ON

DIP

1      2  

56

7

8

3      4  

ON

OFF

ON, OFF, or blinking  
depending on status