Nova Natural NOVA-7820 VIA C3 Processor CPU Embedded Board 사용자 설명서

 38

Set this option to Enabled to enable the floppy drive controller on the 

motherboard.  The settings are Auto (AMIBIOS automatically determines if 

the floppy controller should be enabled), Enabled, or Disabled. 

 

This option specifies the base I/O port address of serial port A.  The 

settings are Auto (AMIBIOS automatically determines the correct base I/O 

port address), Disabled, 3F8h, 2F8h, 2E8h, or 3E8h. 

 

This option specifies the base I/O port address of parallel port on the 

motherboard.  The settings are Disabled, 378h, 278h, or 3BCh. 

 

 

This option specifies the parallel port mode. 

The settings are Normal, Bi-Dir, EPP, or ECP. 

Normal: The normal parallel port mode is used. 

Bi-Dir: Use this setting to support bi-directional transfers on the parallel 

port. 

EPP: The parallel port can be used with devices that adhere to the 

Enhanced Parallel Port (EPP) specification.  EPP uses the existing parallel 

port  signals to provide asymmetric bi-directional data transfer driven by  the 

host device. 

ECP: The parallel port can be used with devices that adhere to the 

Extended Capabilities Port (ECP) specification.  ECP uses the DMA protocol 

to achieve data transfer rates up to 2.5 Megabits per second.  ECP provides  

symmetric bi-directional communication. 

 

This option specifies the IRQ used by the parallel port.  The settings are 

Auto, (IRQ) 5, (IRQ) 7. 

 

This option is only available if the setting for the Parallel Port Mode option is 

ECP.  This option sets the DMA channel used by the parallel port.  The 

settings are DMA Channel 0, 1, or 3. 

 

This option specifies the IDE channel used by the onboard IDE controller 

The settings are Disabled, Primary, and Secondary.