Kenwood AUDIO PROCESSOR 사용자 설명서
GETTING STARTED TUTORIAL
-17-
Audio Input Gain (5) so that 2 or 3 Green Bar Graph LED’s
light up. This may require adjusting both the Mic Gain control
on the 8 Band EQ and the Audio Gain control on the EQplus.
light up. This may require adjusting both the Mic Gain control
on the 8 Band EQ and the Audio Gain control on the EQplus.
Using The EQplus headphone (PHONES) Monitor
Connect a set of stereo headsets into the 1/4 inch “Phones”
Connector located in the back of the EQplus. Talk into the mic
to hear audio coming from the EQplus. Adjust the headset
volume by turning the front panel Monitor Level control (17)
Connector located in the back of the EQplus. Talk into the mic
to hear audio coming from the EQplus. Adjust the headset
volume by turning the front panel Monitor Level control (17)
Adjusting an External Equalizer connected to the EQplus
If you are using an external audio device, such as a W2IHY
8 Band EQ, use the same equalizer settings you were using prior
to using the EQplus.
8 Band EQ, use the same equalizer settings you were using prior
to using the EQplus.
Adjusting the EQPlus Dual Band EQ
Turn the Equalizer Switch (7) on. Turning the Treble
potentiometer (9) clockwise up will increase the amount of high
frequencies present in the Audio Out (23) The detent midway
through the rotation is 0dB gain point. Turning the Bass
potentiometer (8) clockwise will increase the amount of low
frequencies present in the Audio Out (23) The detent midway
through the rotation is the 0dB gain point. Experimentation will
be required to determine the optimal settings for the Equalizer.
potentiometer (9) clockwise up will increase the amount of high
frequencies present in the Audio Out (23) The detent midway
through the rotation is 0dB gain point. Turning the Bass
potentiometer (8) clockwise will increase the amount of low
frequencies present in the Audio Out (23) The detent midway
through the rotation is the 0dB gain point. Experimentation will
be required to determine the optimal settings for the Equalizer.
USING THE COMPRESSOR/ DOWNWARD EXPANDER
- With the Compressor/ Downward Expander off, the audio
level, as seen on the LED Bar Graph, should be adjusted so
that 2 or 3 green LED’s are on. This level may be adjusted
using the Audio Input Gain control (5).
- Turn the Compressor / Downward Expander on (10). Turn the
DE (Downward Expander ) control (12) fully counter
clockwise. This will effectively turn the Downward Expander off.
..
- With the Compressor/ Downward Expander off, the audio
level, as seen on the LED Bar Graph, should be adjusted so
that 2 or 3 green LED’s are on. This level may be adjusted
using the Audio Input Gain control (5).
- Turn the Compressor / Downward Expander on (10). Turn the
DE (Downward Expander ) control (12) fully counter
clockwise. This will effectively turn the Downward Expander off.
..