Furuno IF-NMEASC 사용자 설명서
5. MAINTENANCE, TROUBLESHOOTING
13
Self test 2
This test checks this unit's processor and output for proper operation.
1. With the display showing " - - - .1", push the [Menu/Cancel] button. The display shows "- - - 2".
2. Press the [Enter] button to start the test.
If the results are normal all LEDs light. Then, the nine LEDs below the display flash and the
display shows "End.2".
display shows "End.2".
3. Press the [Enter] button to return to the self test 2 display.
5.5
Memory Clear
The memory can be cleared to restore the default settings for the NMEA ports. Note that offsets
are not cleared.
are not cleared.
1. Hold down the [Menu/Cancel] button together with the [+] button until the display shows "-
CLR". At this time all Status and Settings LEDs are on.
2. Press the [Enter] button to clear the memory and restore all default settings. "END C" appears
upon completion.
3. After the memory is cleared, press the [Menu/Cancel] button to show the heading.
GPS OUTPUT PROCESSING
SENSOR1
SENSOR2
IF-NMEASC status
-
+
Enter
Menu/
Cancel
Self test 2 activated
Heading
Pitch
Sentence
Roll
Bps
Output
Interval
Bps
Sentence
Output
Interval
GPS OUTPUT PROCESSING
SENSOR1
SENSOR2
STATUS of IF-NMEASC
-
+
Enter
Menu/
Cancel
L R
C
Heading
Pitch
Sentence
Roll
Bps
Output
Interval
Bps
Sentence
Output
Interval