Jeep 50-0284x-015 Series 사용자 설명서

                                                                                                6

 

13. Release video screen from locked position. 
      Lower video screen to viewing position for           
      access to mounting location in top of video  
      system housing.  
14. Raise video system into approximate position       
      and connect all wiring to components. Connect    
      wiring and cabling to video system per  
      instruction included with video system. 
15. Check function of all component and lights.  See 

operating instruction for video system operations check.  
For further assistance, refer to the video  

      system manual for the technical support phone  
      number listed for your area. 
 
 
 
16. Insert video system into opening in console.  
      Note : Make sure wires do not get pinched between video system and console. 
      Align holes in housing with clips in mounting bracket. Secure using (4) four 6-32x 3/4" screws 

(item 2 pg.2) and (4) four 3.5mm washers (item 3 pg. 2). See Figure 8. 

     Caution : Do not overtighten screws.  

           
17. Tighten screw previously installed  to secure rear of       

console to headliner. 

vehicle roof may occur. 

18. Raise video screen into locked position. 
19. Install speaker grille (item 9 pg 2). Align clips in grille 

with holes in console and press firmly. See Figure 9. 

20. If speaker upgrade kit was not installed, install cover 

plate (item 10 pg 2) at front of console and secure using 
(2) # 6 X 1/2" screws (item 5 pg 2). 

21. Install  cover plate decal (item 11 pg 2). 
 
 

 
 

 

 

FIGURE 8 

FIGURE 9