ArtDio IPF-3000 사용자 설명서

Quick Installation Guide

IPF-3000 

 

-15-

Note 1: Since the network administrator has to configure the NAT/firewall to map 

those UDP ports to your IPF-3000, thus you should use static IP instead of 

DHCP as your network configuration. Otherwise you take the risk that the 

IPF-3000  would get a different IP from the currently set into the mapping 

when it reboot and re-get its IP by DHCP.   

Note 2: If there are several phones reside under the same NAT, their NAT port 

mappings must not be overlapped since they all share the same NAT resource! 

z  Configure SIP service signaling port:『Main Menu』=>『6.Network』/『2.SIP settings』

/『1.SIP service』. Take the scenario above as an example: 

1.  Transport: 1 (or 3, you must include UDP anyway). 

2.  SIP port: 10101 

z  Configure RTP ports by going to 『Main Menu』=>『6.Network』/『3 RTP settings』. 

Take the mapped ports as an example:   

1.  Base: 10102    (Must be an even number and between 3000 and 65532) 

2.  Range: 6 (Must be an even number and larger than or equal to 4). 

Note: RTP ports are used for voice media transmission. Those ports must be 

consecutive and start with an even number. Besides, at least 4 ports are needed 

for a phone equips with a capacity of two concurrent calls, where each channel 

needs 2 ports for RTP/RTCP. 

z  Assign static NAT IP by going to『Main Menu』=>『6.Network』/『4.NAT & firewall』

/『3.Static NAT IP』 and fill in the acquired NAT IP from network administrator, such 

as  210.95.168.1 mentioned above (you may also detect your NAT IP by STUN 

from  『Main Menu』=>『6.Network』/『4.NAT & firewall』/  『1. STUN』/  『2. 

Diagnose NAT』). 

: if your NAT equipped with no fixed IP, such as those NATs dial into WAN by 

PPPoE, then you must synchronize the NAT IP currently set into IPF-3000 

whenever your NAT IP changed (Such as NAT re-dialup). By default, the 

system will auto-detect the NAT IP (if the STUN server configured into 

menu-6.4.1.1『STUN server』is viable) and notify you by sending an instant 

message whenever it determine a mismatch between the NAT you configured 

into menu 6.4.3-『Static NAT IP』and the one it auto-discovered by STUN 

protocol. Alternatively, you may go to『Main Menu』=>『6.Network』/『4.NAT 

& firewall』/『4.Dynamic NAT IP』and enable『2.Update by STUN』to 

auto-refresh the newly changed NAT IP into menu-6.4.3『Static NAT IP』

whenever it detects an inconsistency. 

z Enable Assigned static NAT IP by going to 『Main Menu』=>『6.Network』/『4.NAT 

& firewall』/『2.UDP traversal』, selecting『2.Static NAT map』and press【HOLD】

 

to confirm activation.