Beurer PM80 작동 가이드

51

G
B

You can either start the EasyFit software by double-
clicking on the EasyFit symbol or via the start menu. If 
you start the software for the first time, please input 
your personal data under New Registration and con-
firm it with Save.

1.  In the menu Administration | Logs click on the button Transfer

data.

2.  The software requests you to connect the HR watch to the PC. 

To do this, please use the data transfer cable supplied. The ca-
ble consists of two connecting components, a USB connector 
for the PC and a clip for the HR watch. It is important for proper 
data transfer that first of all the clip is in contact with all three 
connector pins on the backside of the HR watch. Then connect 
the USB connector to a vacant USB port on your PC. 

3.  As soon as you have connected the data transfer cable and thus 

have established a connection, the HR watch monitor shows PC 
Link. The data is transferred into the software. PC OK shows 
that the transfer has been finished. Remove the USB connector 
from the port. You can view and analyze the updated data in the 
software or close the software via the button Exit. Please note 
that after transfer, all recordings in the memory of the HR watch 
will be deleted.  

4.  If there is an error in transfer, the monitor shows PC ERR. The 

recordings stay in the memory of the HR watch. You can try to 
start a new transfer.

 Remove the USB connector from the port 

and repeat steps 

1 to 3. Please pay attention to the sequence.