Advantech Modem ADAM-4550 사용자 설명서

ADAM-4550 User's Manual

11

1. The address between F8h and FFh

are used for non-addressable modules.
The addresses for addressable modules
are between 00h and F7h.

2. The ADAM-4550 can be configured

as either a MASTER type module or a
SLAVE type module.  The MASTER
ADAM-4550 is the module connected to
the host PC.  The SLAVE ADAM-4550s
are those connected to remote RS-485
devices or other ADAM series products.
Run your configuration program
ADAM4550.EXE to set the unit to the
correct type.

6.

Disconnect INIT pin from the ground pin af-
ter configuration is complete.

During the Get or Set configuration pro-

cess, the configuration software will au-
tomatically search the unit for current
settings using a certain default ID ad-

dress.  If the unit does not respond, a
scanning address dialog box will appear.
Click OK in the box to start the scan-
ning process.  Now the configuration
software will scan for ID addresses be-
tween 0 and 255.  The current settings
of the unit will be displayed when the
units address is found.  Users can also
change the time-out value in the scan-
ning dialog box to allow more scanning
time for the configuration software.

1.

Follow the procedures in sections A.1 and
A.2 and start the Adam Configuration and
Diagnostic Program.

2.

Select the Setting... menu and choose Lo-
cal.  A dialog box will open.  Select  the
proper COM port connected to the ADAM-
4550 and set the baud rate to 9600.  Click
the OK button.