Agri-Fab 45-03083 사용자 설명서

4

•  Cut from top to bottom all four corners of the carton 

and lay panels flat. (See Fig. 1)

•  Remove the lag screw that holds the floating hitch to 

the packing skid.

•  Disassemble and discard carton's wood top and side 

supports.

•  Remove four hex bolt, hex nuts and flat washer from 

the hold down brackets at the rear of the carton.

•  Remove and 

save the two Flat Washers and Cotter 

Pins from the rear axle. Reuse when attaching gauge 
wheels.

•  Discard all other packing hardware and hold down 

brackets.

•  Assemble Gauge Wheels onto the Rear Axle with the 

extended end of Hub facing inward. Secure with the 
Flat Washers and Cotter Pins which you removed from 
the axle during unpacking. (See fig. 2.) 

•  Right hand (RH) and left hand (LH) are determined 

from the drivers position while seated on the tractor.

•  We recommend that you remove the Mower Deck 

before using the Tiller. Refer to your Tractor Owner's 
Manual.

3/8" NYLOCK
NUT

•  Attach the floating hitch to the tractor's draw bar. 

(Refer to Operating Instructions on page 7.)

•  Remove the preassembled 3/8" x 2" hex bolt and 3/8" 

nylock nut from the L.H. Tine Assembly. Slide the tine 
assembly onto the Transmission Axle on the left side 
of the tiller and secure with the hex bolt and nylock nut. 
(See fig. 3.) Repeat for the R.H. side.