Digi Tech Control 2 사용자 매뉴얼
Selecting Banks
The Control 2 assigns groups of presets (called banks) to the numbered
footswitches. Each bank is a group of 5 presets (5 Patch Mode) or 10 presets
(10 Patch Mode) depending on the foot controller mode selected by the GSP.
Hence, there are 20 banks in 5 Patch Mode and 10 banks is 10 Patch Mode.
footswitches. Each bank is a group of 5 presets (5 Patch Mode) or 10 presets
(10 Patch Mode) depending on the foot controller mode selected by the GSP.
Hence, there are 20 banks in 5 Patch Mode and 10 banks is 10 Patch Mode.
To select a new bank and a new preset, follow these steps:
Press either the Bank Down or Bank Up footswitch. The name of
the newly cued bank appears in the Display and the available preset
footswitches flash (1-5 in 5 Patch Mode and 1-10 in 10 Patch Mode).
the newly cued bank appears in the Display and the available preset
footswitches flash (1-5 in 5 Patch Mode and 1-10 in 10 Patch Mode).
Bank Down & Bank Up
To make the bank shown in the Display active you must load a new
preset by pressing one of the flashing preset footswitches. If no
footswitch is pressed within 5 seconds, the Control 2 will abort the
bank change and return to the preset prior to the bank footswitch being
pressed.
preset by pressing one of the flashing preset footswitches. If no
footswitch is pressed within 5 seconds, the Control 2 will abort the
bank change and return to the preset prior to the bank footswitch being
pressed.
Banks are also changed when selecting presets using the Edit/Select knob
on the GSP. For example, if any of presets 1-5 are selected on the GSP in 5
Patch Mode, the bank titled Presets 1-5 will be the active bank on the
Control 2 and numbered Footswitches 1-5 would select presets 1-5. If preset
6 is then selected using the Edit/Select knob on the GSP, Presets 6-10
will now become the active bank and numbered Footswitches 1-5 would then
select presets 6-10.
on the GSP. For example, if any of presets 1-5 are selected on the GSP in 5
Patch Mode, the bank titled Presets 1-5 will be the active bank on the
Control 2 and numbered Footswitches 1-5 would select presets 1-5. If preset
6 is then selected using the Edit/Select knob on the GSP, Presets 6-10
will now become the active bank and numbered Footswitches 1-5 would then
select presets 6-10.
Note that banks titled Presets 96-99 (5 Patch Mode) and Presets
91-99 (10 Patch Mode) contain only 4 and 9 presets respectively. When one
of these banks is selected, Footswitch 5 (5 patch mode) and the CONTROL
Footswitch (10 patch mode) have no function.
91-99 (10 Patch Mode) contain only 4 and 9 presets respectively. When one
of these banks is selected, Footswitch 5 (5 patch mode) and the CONTROL
Footswitch (10 patch mode) have no function.
1.
2.
Using the Control 2 Remote Foot Controller
Control 2 Owner’s Manual