Delphi XM SKYFI3 사용자 설명서

1.  Install the SKYFi3 cradle insert onto the Delphi Premium Sound System. 

Insert the SKYFi3 receiver (sold separately) into the cradle insert included 
with the Delphi Premium Sound System until snug. 

 

Caution: Do not use excessive force when inserting the receiver into the 
cradle. Doing so could cause damage to the unit.

2.  Place the cradle insert containing the SKYFi3 into the cradle by first press-

ing in on the back of the black inset cradle in the Delphi Premium Sound 
System. Then let the cradle tilt forward, carefully slide the cradle insert 
down into the tray so that the alignment tabs on the sides of the tray line 
up with the slots on the cradle insert and the connector is completely 
seated. Push on the top center above the display of the cradle insert  
so that it tilts back into the Delphi Premium Sound System until a click  
is heard. The SKYFi3 Receiver adaptor can be removed by reversing  
this process.

3.  Power up the system by using the power button on the receiver or on the 

remote control. If the display reads “ANTENNA” after powering up, check 
that the antenna connection is secure and completely pushed in. Next, 
change channels (from 0 to 1 or from 1 to 0 if the receiver is not activated 
yet). If the “ANTENNA” message remains, power down the radio, unplug 
the antenna, and look for any obvious damage in the connector, jack, or 
antenna cable. If no damage is detected, reconnect the antenna, turn the 
unit back on, and change channels again. If the message still  
appears, contact your retailer.