Bose VCS 10 Series II 사용자 설명서

If you have a problem with your Acoustimass 10 Series II speakers, turn off your sound
source and try the solutions below. If you still have a problem, contact your Bose

®

 dealer to

arrange for service. Or, to contact Bose directly, refer to the inside back cover of this guide.

System does not

• Make sure the power cord of the receiver is plugged into an operating AC wall outlet and

function at all

that the unit is turned on.

• Be sure to select a source at the receiver (video, DVD, CD, tuner).

No sound

•  Check the speaker connections. Turn the unit ON.
•  Increase the volume.
•  Disconnect any headphones.

Sound is distorted

•  Make sure speaker cable is not damaged.
•  Reduce the volume of any external components connected to the receiver.

No bass

•  Make sure the speaker connections at the receiver or amplifier are correct (+ to + and - to -).
• If you are using Dolby Digital (AC-3) programming, verify that the settings are correct at the

receiver. Be sure the source material (laserdisc, DVD, or broadcast programming) is Dolby
Digital encoded.

Not enough or

•  Move the Acoustimass module closer to a wall or corner to increase bass. Move it farther

too much bass

from a wall or corner to decrease bass.

• Set the “Loudness” or “Bass Boost” control on your receiver to increase or decrease bass.

No surround-sound

•  To get the full performance benefit, your HiFi Stereo VCR or stereo television must be

connected to a home theater receiver.

• Make sure your receiver is set to a surround-sound mode.

For additional help in solving problems, contact Bose customer service. See the inside back
cover for Bose customer service offices and phone numbers.