Bolens 930 SWE 서비스 매뉴얼

Snow thrower controls and features are described below 
and illustrated  in Fig. 4-1. 
NOTE:  For detailed information on all engine controls, 
refer to the separate Tecumseh Engine Operator’s Manual.

The shift lever is located in the right side of 
the handle panel and is used to determine 
ground speed and direction of travel.

There are six forward (F) speeds. Position one 
(1) is the slowest and position six (6) is the 
fastest. 

There are two reverse (R) speeds. One (R1) is 
the slower and two (R2) is the faster.

The choke control is found on the rear of the engine and 
is activated by rotating the knob clockwise. Activating the 
choke control closes the choke plate on the carburetor and 
aids in starting the engine.

The ignition key is a safety devise. It must be fully inserted 
in order for the engine to start. Remove the ignition key 
when the snow thrower is not in use.
Important: Do not turn the ignition key in an attempt to 
start the engine. Doing so may cause it to break.

Drive Control

Headlight

Fuel Tank

Gas Cap

Oil Fill

Chute

Assembly

Clean-Out 

Tool

Auger Control

Shift Lever

Two-Way 

Chute Control™

Wheel Steering 

Control

Chute Directional

Control

Skid Shoe

Augers

Engine Controls

Recoil Starter 

Primer

Ignition 

Key

Handle

Electric Starter

 Switch

Bulb

Choke 

Control

Throttle

Control