Lennox Hearth H3541 CUGK35C 35" CHARCOAL 사용자 설명서
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 2
- Remove Upper and/or Lower Panel(s)
Top Panel
Removed
Trim Panels will
be either Lou-
vered Panels or
Radiant Panels.
be either Lou-
vered Panels or
Radiant Panels.
Louvered
Panels
Panels
Radiant
Panels
Panels
WARNINGS
•
Hot! Do not touch! These decorative grilles
are NOT heat guards. Carefully supervise
children in the same room as appliance.
are NOT heat guards. Carefully supervise
children in the same room as appliance.
•
The lower Grille covering the controls will
become hot during operation. Use care when
removing the grille to access the controls and
make sure to place the grille on a surface that
is non-combustible or will not be damaged by
high temperatures.
become hot during operation. Use care when
removing the grille to access the controls and
make sure to place the grille on a surface that
is non-combustible or will not be damaged by
high temperatures.
• INSTALL THIS KIT ONLY WHEN THE FIREPLACE IS OFF
AND COLD!
Read and understand all instructions and warnings in this docu-
ment before beginning the installation.
ment before beginning the installation.
TOOLS REQUIRED
Phillips Screwdriver
Cutting Pliers
Cutting Pliers
(required for modesty panels with side locating tabs only as
shown in Figure 6)
GENERAL INFORMATION
These decorative grilles are offered in four attractive fi nishes and fi t on the
face of the appliance in place of the standard louvers or radiant panels. If you
encounter any problems, need clarifi cation of these instructions or are not
qualifi ed to properly install this kit, contact you local distributor or dealer.
face of the appliance in place of the standard louvers or radiant panels. If you
encounter any problems, need clarifi cation of these instructions or are not
qualifi ed to properly install this kit, contact you local distributor or dealer.
2
Figure 3 - Remove Hinged Lower Panel
Control Compartment
Access panel
OPENING CONTROL COMPARTMENT DOOR
Control Valve
Lower Control
Compartment Door
Compartment Door
Lift the Lower Control Compartment
Door up and pull out to remove.
Door up and pull out to remove.
Up
Out
Hook Catch
Lower Panel - Remove the lower louvered or radiant panel assemby as
follows:
• Hinged Panel (see Figure 3) - Gently depress the outer top corners of
the louvered Control Compartment Access Panel until the spring-loaded
magnetic catches "pop" it free, allowing it to swing out and down to
open. With the panel in the open position, depress the spring-loaded
hinge pin on left side until it disengages from the left cabinet panel
hole. Pull panel away from fi replace.
magnetic catches "pop" it free, allowing it to swing out and down to
open. With the panel in the open position, depress the spring-loaded
hinge pin on left side until it disengages from the left cabinet panel
hole. Pull panel away from fi replace.
INSTALLATION INSTRUCTIONS:
1. Remove Louvered or Radiant Panel/Hood Assembly -
Upper Panel - Remove the upper louvered or radiant panel/hood assembly
by pulling the assembly up and out (see Figure 2). In instances where
the radiant panel is used and it is framed in with tile or other approved
material, the hood must still be removed by fi rmly pulling it forward until
it releases from the receiving brackets.
the radiant panel is used and it is framed in with tile or other approved
material, the hood must still be removed by fi rmly pulling it forward until
it releases from the receiving brackets.
• Hooked Panel (see Figure 4) - Remove the panel by gently lifting it
upward until the hook catches on boths sides clear the locating slots.
Then pull door out to remove.
Then pull door out to remove.
Figure 4 - Remove Hooked Lower Panel
Hinge Pin
Latch for
Glass Door