Danby DAC250EUB1GDB 사용 및 관리

Install Chassis into Cabinet and Install:
1.  Lift chassis and carefully slide into cabinet, leaving 6 inches protruding.
2.  DO NOT push on controls or coils.
3.  Be sure the chassis is fi rmly seated towards rear of cabinet. 
4.  Installation of front is the reverse of removal, outlined in section 1 (“Remove Chassis”)

h

• 

DO NOT use gasoline, benzene, thinner, or any other chemicals to clean this unit, as these substances may cause 
damage to the fi nish and deformation of plastic parts.

• 

Never use harsh cleaners, wax or polish on the cabinet front.

The air fi lter should be checked at least once a month to see if cleaning is 
necessary. Trapped particles in the fi lter can build up and cause accumulation 
of frost on the cooling coils. 
• 

Push the vent handle to the vent closed position.

• 

Open the front panel.

• Grasp 

the 

fi lter, pull up and out.

• Wash 

the 

fi lter using liquid dishwashing detergent and warm water. Rinse 

fi lter thoroughly.

• 

Gently shake excess water from the fi lter. Be sure the fi lter is thoroughly 
dry before replacing. 

• 

You may vacuum the fi lter to clean.

Note: Never use hot water over 40°C (104°F) to clean the air fi lter.