Frigidaire FFED3025PW 사용자 매뉴얼

다운로드
페이지 37
10
BEFORE SETTING SURFACE CONTROLS
Hot Surface Indicator Light (some models)
The hot surface indicator light located on the cooktop will 
glow when any surface cooking area heats up and will 
remain on until the glass cooktop has cooled to a moderate 
level (See 
Home Canning
Be sure to read and observe all the following points when 
home canning with your appliance. Check with the USDA 
(United States Department of Agriculture) Web site and be 
sure to read all the information they have available as well 
as follow their recommendations for home canning proce-
dures.
Use only quality flat bottom canners when home 
canning. Use a straight-edge to check canner bottom.
Use only a completely flat bottom canner with no ridges 
that radiate from the bottom center when home 
canning. Heat is spread more evenly when the bottom 
surface is flat.
Make sure the diameter of the canner does not exceed 
1 inch beyond the surface element markings or burner. 
It is recommended to use smaller diameter canners on 
electric coil and ceramic glass cooktops and to center 
canners on the burner grates.
Start with hot tap water to bring water to boil more 
quickly. 
Use the highest heat seating when first bringing the 
water to a boil. Once boiling is achieved, reduce heat to 
lowest possible setting to maintain that boil.
Use tested recipes and follow instructions carefully. 
Check with your local Cooperative Agricultural 
Extension Service or a manufacturer of glass jars for 
the latest canning information.
It is best to can small amounts and light loads.
Do not leave water bath or pressure canners on high 
heat for an extended amount of time.
Alternate surface units between each batch to allow the 
units and surrounding surfaces to cool down. Try to 
avoid canning on the same burner unit all day.
Figure 4:
Hot surface indicator light location
The hot surface indicator lights will glow when the 
element is turned on and will continue to glow after the 
control knob is turned to the OFF position. It will glow until 
the heating surface area has cooled sufficiently. The 
glass surface may still be hot and burns may occur if the 
glass surface is touched before the indicator light has 
turned off.
hot surface
indicator
light
NOTE
Canning can generate large amounts of steam. Use 
extreme caution to prevent burns. Always raise the lid to 
vent steam away from you. Safe canning requires that 
harmful micro-organisms are destroyed and the jars are 
sealed completely. When canning in a water bath canner, 
a gentle but steady boil must be maintained continuously 
for the required time.
CAUTION