Zephyr CTPE48BSX 사용자 매뉴얼

www.zephyronline.com

1.  Determine the location for mounting the hood. Mark centerlines front to back and left to right of hood placement. Place 

supplied paper template on ceiling and center marked center lines with template center lines. Mark mounting holes for 
ceiling bracket and telescopic rod couplers. 

2.  Cut out hole in ceiling for the duct work and electrical wiring passage. 

3.  Add and secure wook blockings (minimum 2x4 studs) between ceiling joists for celing bracket and telescopic rod 

couplers if needed. FIG. 1.

4.  Center, mark and fasten ceiling bracket onto ceiling using (4) M4*38 screws and (4) washers. Make sure the word 

“FRONT” displayed on the ceiling bracket is facing the front of the hood where the controls will be located. FIG. 2.

5.  Attach telescopic rod couplers to marked locations on ceiling using (1) M4*2” wood screw for each coupler. Make sure 

the set screw mounting hole is toward the bottom of the coupler during mounting. FIG. 2.

6.  Prepair and position electrical wiring and duct work through ceiling bracket.  

For personal safety, remove house fuse or open circuit breaker before beginning installation. Do not use extension cord or adapter plug 
with this appliance.

Electrical Supply: This appliance requires a 120V 60Hz electrical supply, and connected to an individual, properly grounded branch 
circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire w/ ground. Please also refer Electrical
Diagram labeled on product.

Cable Lock: A cable locking connector (not supplied) might also be required by local codes. Check with local requirements and codes, 
purchase and install appropriate connector if necessary.

Add Blockings

Tabs

Tabs

Ceiling Bracket

CL

CL

Mounting

Holes

Marking for Coupler

Electrical wiring 

passage

Ceiling

Set screw mounting

hole

FRONT