Thermador SGS304FS 설치 설명서
English 4
NOTE:
All measurements given have to be precisely followed. If
nonstandard cabinets are used, make sure they are
installed with minimum dimensions shown in Figure 1 and
Figure 2.
All measurements given have to be precisely followed. If
nonstandard cabinets are used, make sure they are
installed with minimum dimensions shown in Figure 1 and
Figure 2.
Plan the installation of the unit so that the power cord, gas
shut-off valve and gas pressure regulator are accessible
from the front of cabinet.
shut-off valve and gas pressure regulator are accessible
from the front of cabinet.
Countertop Requirements
Mounting Requirements
Use the mounting brackets supplied. See “Install the
Cooktop” on page 5 for further details.
Cooktop” on page 5 for further details.
Ventilation Recommendations
We strongly recommend the installation of a ventilation
hood above this appliance. The hood must be installed
according to instructions furnished with the hood.
hood above this appliance. The hood must be installed
according to instructions furnished with the hood.
Installation Procedure
WARNING:
To avoid electrical shock hazard, before
installing the cooktop, switch power off at the
service panel to prevent the power from being
switched on accidentally.
installing the cooktop, switch power off at the
service panel to prevent the power from being
switched on accidentally.
Figure 1:
Installed Dimensions (from Cooktop Edges
)
Depth from Back Wall
Cabinet 13" (33cm) max.
Hood Depth - 24" (61cm) max.
Centered Over Cooktop
Rear Wall - 1-3/4"(4cm)
Right Side
12" (30cm) min.
Left Side
12" (30cm) min.
18" (46cm) min.
Above Counter - 30" (76 cm) min. to
Combustible Surface
SGS(X)30 - 30" (76cm) min.
SGS(X)36 - 36" (91cm) min.
Figure 2: Cutout Dimensions
30” Models
36” Models